![bacini acoustica speaker manual bacini acoustica speaker manual](https://www.radiomuseum.org/images/radio/yamaha_co_hamamatsu/natural_sound_stereo_amplifier_ca_662298.jpg)
Note that you may run into conversion delay, I don´t know if Mixcraft compensates that out. You may need to do assignments in your Roland´s user interface (mixer) software. I see your interface has ten outputs, so mixcraft should be able to see them and direct audio to them. You can change that by creating (like a normal track) an output track. This is wired to Mixcraft´s stereo output. It seems you are determined to do so, or rather, "stuck".Īll tracks go to the master track per default. GovernmentMule wrote:Are you trying to send a track or tracks out of mixcraft to your hardware effects and back into mixcraft and then mixdown? Monitoring is activated on the audio track (by clicking the speaker icon with the trackĪrmed), the tape delay’s output will be heard alongside all other mix elements." The tape echo’s output can then be recorded.
![bacini acoustica speaker manual bacini acoustica speaker manual](https://i5.walmartimages.com/asr/e49068f8-4192-4c55-8b33-a81fc61ddaba_1.4e3586491e3b5b8fe625f93e1021a554.jpeg)
![bacini acoustica speaker manual bacini acoustica speaker manual](http://srv2.umlib.com/2556b37a9797107c28a7cbc629074706/HXWA30_ADV.PDF-0.png)
Select a physical input on the audio interface using the track To return the affected sound to Mixcraft’s mixer, create a new Audio Track, The selected output of the audio interface is physically plugged into the The vocal track’s send knob is routed to the Send Track, which is then sent to the This allows an external hardwareĮffect to behave the same as a Send Track with an onboard plug-in effect. Routed to a specific output on the audio interface. The Send Track has been routed to an Output Track, which has been The example below, a Send Track has been created to make use of a vintage tape delay Sometimes classic hardware effects are the only way to achieve a specific sound.
Bacini acoustica speaker manual manual#
I did find this in the manual on page 40. Hopefully Eric,Greg or somebody else can answer this for you. Are you trying to send a track or tracks out of mixcraft to your hardware effects and back into mixcraft and then mixdown? I've never tried this and do not know if it is possible. What I think you are trying to do is use your outboard hardware effects like a send effects on a guitar amp. Hey nitrobarry1, I think there might be a misunderstanding about what you are trying to accomplish here.